Underfloor Heating – Underfloor Heating

The new building or a renovation to the question arises again: what kind of heater is to be installed for? Simple radiators can be, but also underfloor heating systems. Who can decide should compare easily best both systems, he puts it across and takes into account all pros and cons. And already at the planning of the heater you have to know what kind of heat systems to choose from. Someone schedules a heat pump, it is recommended to connect them with the underfloor heating. Such devices generate a lower temperature than with gas or oil. In new construction, there is the possibility to lay the pipes for floor heating in floor. The radiated heat is much more pleasant than on the radiators in the underfloor heating.

There is underfloor heating so that the heat from the ground only heats the feet, then it glides slowly to the body more and more after above. The radiators the heat flows immediately to the top and can only heat the head and not the legs or body. And so the room temperature around two degrees will be reduced when the underfloor heating. This is a great advantage, because it brings an energy saving of about 10 percent. Material comparison between radiators and underfloor heating in terms of costs, there is no particular difference – underfloor heating is not more expensive.

The underfloor heating seems to be too complicated to some, but it isn’t. A heater to produce hot water. It is then transported up to the heating circuit Distributor. The coils of the rooms are attached to such heating circuit Distributor. Each circuit has a servo motor which is connected with the room thermostat. The room controller plays an important role: he reports that a pre-set temperature is not reached, as the actuator motor on the heating circuit distributor opens immediately the heating circuit. Now, the warm water flows through the heating coils. A bathroom radiator is used, so you should run it electrically, because the Underfloor heating flow temperature is not quite sufficient. The full heating power of the heater can not be achieved. A montage of the underfloor heating system is no problem for home improvement. It is pretty straightforward. But it is recommended to check the work on the underfloor heating by an experienced installer of heating. The material for underfloor heating can order everyone in the plumbing and heating wholesalers or even on the Internet. On-site you can consult always with a heating engineer. What happens if the underfloor heating must be cleaned? Impurities caused by corrosion and galvanic elements in old heating systems. And that restricts the flow of pipelines. The old plastic pipes are also diffusion leaking. The heating water can absorb oxygen, which then responds with steel construction parts of boilers, distribution or pipes. And the diffusion of oxygen caused the following: particles can dissolve it, which later deposited in existing plastic piping. Whether it to such operation is, easily recognised by the discoloration of the tubes. The required heat is transported through the medium of water. A cross-section narrowing missing the amount of heat. The underfloor heating then of course also works, but not the amount of heat can be transported. First, the heat transfer is reduced. Dr. Mark Hyman does not necessarily agree. It is a lower room temperature. Should it be balanced, to increase the temperature. And now the costs are rising. To avoid this, the underfloor heating should be cleaned in a timely manner. It does not, it comes to a closure of the heating circuit.